modelrail.otenko Trains, computers, vintage, retro, model railways… the lot…

Atari 2600 Jr – Recapping + Controllers + Composite

Another one of these little units came across my workbench. This time it was a full set with two joysticks and a lot of games... including a boxed version of Frogger! I'd played with one of these before in my previous-previous apartment, so it must be nearly 4 years ago that I met my first Atari. This one wasn't as clean-and-tidy as the previous version, but it still worked nicely.

The first task was to upgrade the unit to composite output, so I jumped over to my previous post on the topic. I purchased all the components needed from Jaycar and, just before I was about to solder to the pins on the IC, realised that the actual mod instructions showed you where to solder. Not to the pins of the IC, but to the legs of the surrounding resistors.... the diagram is even colour-coded. I therefore also didn't have to scratch back a ground pad either!

In no time, the composite signal was being sent out and my TV Tuner card was picking it up nicely. Whilst I was performing the mod, I noticed that the surrounding electrolytic capacitors weren't looking the cleanest, so I replaced those too. After another trip to Jaycar, purchasing 4x 4.7uf and 1x 2200uf (unfortunately they didn't stock double-ended!) capacitors, I went about removing the old ones and soldering in the new ones. Solder wick really works well here to clean the holes in the PCB prior installing the new capacitors. The positive pins are also nicely marked on the PCB.

With everything replaced, there was no noticeable change in video quality or system stability, but neither were a problem to start with. This was more for longevity! I slapped in the multi-cart and tried Pitfall out. The Quickshot controller worked OK, but felt very sticky and the buttons weren't responding to each keypress... what to do? Pull it apart.

The board was not clean... so I grabbed some isopropyl wipes and gave it a good once-over. I also re-soldered the main A button wire as it had previously been compressed by the case and didn't look like it'd hold out much longer. With the unit back together, I could now jump on-command with the button on the base, but the trigger button up top wasn't overly responsive. The stick itself has three screws that hold it together, so I popped them out to have a look.

Turns out the top button had been mashed to within an inch of its life and the previous players had actually punched a hole in the PCB, removing the trace that the button was meant to make contact with.

A little bit of solder was added, which caused a height increase of the pad. I was slightly concerned that this would mean the button could mis-fire, but the spring prevented that from occurring... instead it just meant the button didn't have to travel as far to make contact. I could now jump through Pitfall reliably! Mario Bros was also now a lot more fun!

I suppose the final step now is to find a new ball for the top of this chewed-on stick!