Subscribe via RSS

Yet another layout…

It was about time to fill the table I'd bought from an op-shop a long time ago. I'd attempted a layout for this prior using the Arduino and CAN Bus to control it... but I somehow lost interest and demolished it. Hence we begin with the 810mm(Squared) Table Layout Version 2.0.

The space was relatively small and, thanks to my previous attempt, I knew there wasn't going to be much more than a loop-the-loop. The whole reason for building this was to run my 300 Series Shinkasen and that meant wide curves and wide clearances. For some reason I then decided that a loop-the-loop was boring and that I could fit a loop-the-loop-the-loop in.

I set to work on Anyrail.Net and found that a triple-loop was going to be tight. Unitrack had enough different radii curves to get the loops in, but I'd have to be using the tightest available... not too good for a 7-car Shinkansen. So... I started breaking the mould and making everything not-quite-fit together in the layout software. This meant slightly wider curves but potentially dangerous track joins where I would be 'stretching' the limits of unitrack to fit. Fortunately it turns out to be pretty forgiving.

I went to a not-so-local hobby store and found they had a HUGE selection of Japanese stock. I had my list printed from Anyrail and went about collecting. I also got some Walthers gradient foam for my crazy layout.

DSC01569 DSC01570 DSC01571

After a little fiddling the track was laid out and temporarily elevated into place. It all worked... but was a squeeze. With nothing stuck down you'd attempt to get track to connect in one spot and it'd fall out of alignment in another... I don't really recommend jamming Unitrack together in odd formations!

DSC01574 DSC01576 DSC01578

The result was a successful session of test running with all of the stock I could find!

Comments (0) Trackbacks (1)

No comments yet.

Leave a comment