Subscribe via RSS
10Aug/162

Atari 2600 jr: Composite Video Output + Audio

There seem to be a lot of options (and sites with comparisons of the options) available when adding composite video to the Atari 2600. Some require removing parts and disabling the RF output whereas others just hitch onto components and allow both signals to be produced. Here's a brief list of places to find information:

There's also hardware that you can purchase to make the job a lot easier:

Doing it yourself

I chose the mod available at Lynx's 0,68 Euro ATARI 2600 Junior Composite Mod (German). This mod offered a good balance of circuit complexity and as little atari-destruction as possible. All parts were purchased from the local Jaycar, except for the 330ohm resistor. They were out of stock and so I combined a 300ohm+33ohm.

Here's the final parts list:

  • 1 x 330 Ohm 0.25w Resistor
  • 2 x 1K0 0.25w Resistors
  • 1 x 2K2 0.25w Resistor
  • 1 x 3K3 0.25w Resistor
  • 1 x 100p Ceramic Capacitor
  • 2 x RCA sockets

DSC05540

DSC05544 DSC05545 DSC05548

DSC05550

Construction was very straight-forward... I soldered straight onto the pins and scratched a pad for ground on the nearest plane. I then quickly wired up an RCA plug. I knew I'd need to de-solder it again to mount it into the case, so I didn't over-do the soldering.

DSC05551

Great picture! This is the start screen for the 4-in-1 cartridge. All good... now for audio.

DSC05554

Above you can see two wires heading to the required spot at the base of the resistor. One is folded up... I intend on doing the stereo mod next, so that's there for future-proofing. Currently mono audio is output via the white RCA socket.

UPDATE: My 'future-proofing' was useless... the PAL version of the Atari 2600 jr DOES NOT support stereo sound. So just connect the red plug to the white plug internally!

DSC05557 DSC05558 DSC05559

DSC05561 DSC05562 DSC05563

Now... to play games...

9Aug/160

Atari 2600 jr: Introduction

This was an unexpected surprise. Canberra has a rubbish tip; well, a few, actually. At these tips, back in the day, the dumpers used to drive their cars/trailers/trucks right up to the wall'o'rubbish and offload. Whilst the father was scraping all the rubbish out and launching the bags onto the mountain of junk, the children would be scavenging through other people's discards.

I found many a thing there: old computers (286/386, at that time), model railway paraphernalia, misc. electronics, etc... After a while, too many dead bodies were being found and so they closed the dumping area off to the public. Instead, they built a concrete shed with a big mechanical compactor. Everyone's rubbish was thrown in a corridor and compacted. A truck would then drive it up to the real landfill area.

The public could no longer freely recycle other people's rubbish. It was lost once it went over the wall. An uprising occurred when an entrepreneur decided that he could form an organisation that worked at the tip under appropriate licensing (oh, I love democracy) and legally scavenge the rubbish. This was no good, unless they could actually sell it... so a 'shop' was set up at the rubbish dump. Can you believe this? We have to buy our rubbish back?

Either way... last Sunday... after 2 separate (and dismal) trash and treasure markets, I ended up at the Green Shed. I was initially looking for a bootable DOS disk... not finding much, I was disheartened and about to leave. As you exit the building, you pass the cash register, which is actually a large glass display cabinet. In it was a lost treasure. The attendant had me made: he knew I wanted it and happily quoted a price which would've doubled the takings for the day of the entire shop... but, for the unit, was half the going rate on eBay... as long as it worked!

My first Atari

Last year, I read the book: Racing the Beam. I can't remember how I came across it, but it ended up being a good read on the inner workings of the Atari. I was impressed to find out how they got around hardware limitations and changed the way kids would play games forever.

DSC05493 DSC05494 DSC05495

I had never expected to own one. Especially one in this condition... It turns out this is the Atari 2600 Junior. It's the final version, slimmed down, produced somewhere between 1986 and 1991. It was brown when I got it...being in Canberra, I didn't have any tools with me, so I used floor-cleaning wipes (disinfectant was a great idea at this point) and tore the thing apart. After a good clean, it actually came up remarkably well. The best part was that the 'protective seal' was still on the steel Atari branding on the top of the case. I should've left it on there... but I really love peeling those things off!

DSC05499 DSC05500 DSC05501

The whole loot included two game cartridges, two controllers (one had the screw-in joystick snapped), the base console and the wall-wart. The only thing that was missing was the RF cable. I cleaned it all at home in Canberra. Taking it apart, the solder joints looked fine... there was just a large accumulation of dust. A quick vacuum and wipe down got it into the state above.

I bit the bullet and plugged it into the wall. Toggling the power switch did nothing! Bummer... a dead Atari... I was very happy to have a new project. I popped it back open and scanned all components again. There wasn't anything obvious. I thought I'd leave it until I returned to Melbourne where I could go over it thoroughly with the multimeter. After re-assembling, I quickly tested it once more. The fourth toggle of the power switch saw the red power LED light! Ok... we're in for fun if the grime has gotten ALL THE WAY into the 'enclosed' power switch.

A more complete teardown

I returned to my workbench at home and pulled the machine apart; knowing that there were going to be gremlins in the system. Overall, it looked to be in great condition, but I grabbed the magnifying glass and inspected it all again anyway.

DSC05502

DSC05503 DSC05504 DSC05506

The metal shielding comes off very easily. The top half is secured to the bottom half via metal tabs that have been slightly twisted. Grab a pair of pliers and bend them all straight again... you'll then find that both shields come apart with little force.

DSC05507 DSC05509 DSC05510

After an inspection, I re-vacuumed the switches and grabbed a cartridge. I really wanted to check out Ghost Busters, so that was the obvious choice. Using my trusty BW CRT TV, I hoooked it all together. Scanning the UHF channel, I found no signal. I could get interference when I toggled the power switch, so I thought that I was near the right tuning every so often. I was on UHF because that's what the Commodore 64 used and I assumed that all consoles of that vintage would use the same frequencies. I was wrong. The Atari 2600 uses VHF Channel 2 or 3. This channel is selectable via the switch at the back of the console.

DSC05522 DSC05530 DSC05531

Once on VHF tuning, the signal appeared easily. The console was set to Black and White, so the image was crisp! Even over RF. I wonder if these can do composite? Ghost Busters is pretty hilarious. Actually quite difficult to get started... but I think I'll write a post just for that story.

Top Push Buttons

The Select/Reset buttons to the right of the cartridge port, on top of the console, are spring-loaded via a 'sponge'. This material had deteriorated on both buttons over the decades and needed replacing.

DSC05532 DSC05533DSC05534

I happened to have some packaging material foam on hand and sliced some pieces off to replace the worn out sponge. I scraped the old sponge off first... needed a bit of elbow-grease for this ... was definitely stuck on well! Afterwards I used a bit of double-sided tape to apply the new sponge.

DSC05536 DSC05539 DSC05537

Worked perfectly.

What's next?

Why, games! I've got a total of 36 to test out... so I'll flick through them and report on anything noteworthy. I also want this thing producing a composite signal... so a little research will see that occurring in no time.

28Jul/160

GAME OVER? Amsterdam – Retro Games Store

GAME OVER? has existed for over 14 years, tucked away in a side-street in central Amsterdam. I was very happy to hear this when asking the owner about the history of the shop.

DSC04719

game-over-map

This shop is bursting at the seams! Wall to wall of amazing retro goodness. You'll find everything here from VIC20/C64/Atari through to XBOX/Gameboy/PlayStation. The window is full of relics and will get anyone interested inside. Don't be fooled into thinking that what's on display is all there is to offer... If you know what you're after, then ask away and have the owner dig bits and pieces out for you.

DSC04720 DSC04721 DSC04722

I happened to want one of the controllers in the window; turns out they're all damaged and just for display. I was then lead to a draw, on the left as you walk in, and a motherload of C64/Atari items was presented. Pretty ... much ... heaven. The owners are really friendly and let me take pictures inside the store... so do chat with them; their wealth of knowledge was very helpful!

DSC05140 DSC05141 DSC05143

As you can see from above, I picked up two Atari controllers and my first ever C64 cartridge: Rat Radar Race. Am still to test it, but have been told it is in working order. I couldn't trek half-way across the globe and not purchase a few goodies when they were there in front of me. I actually tried a few of the 'markets' around Amsterdam but found zero retro gaming items.

Check this shop out if you're ever in Amsterdam!